|
Proneb Turbo Guide 6
| |
Next | Back | Proneb
Turbo | Pari | Index |
|
SAVE THESE
INSTRUCTIONS - Bookmark this page. |
|
|
II. SPECIFICATIONS
|
|
|
COMPRESSOR
SPECIFICATIONS: |
|
|
Weight: |
4.2lb. (1.9 Kg) |
|
|
Dimensions: |
6.5 x 3.7 x 5.5 in. (16.5 x 9.5 x 14.0cm) |
|
|
Electrical Requirements: |
120V AC, 60 Hz, 1.1 A or 220-240V, 50/60
Hz |
|
|
Power Wattage: |
65W @ 16 psi |
|
|
Ambient Temperature Range: |
10 C to 40 C, (50 F to 104 F) |
|
|
Transport/Storage Range: |
|
|
Ambient temperature:
|
-40 C to 70 C, (-40 F to 158 F) |
|
|
Relative Humidity:
|
10% to 100%, including condensation |
|
|
Atmospheric Pressure:
|
500 hpa to 1060 hpa |
|
|
EXPLANATION OF
SYMBOLS: |
|
|
On/Off
Type B
Insulation Class II
|
 |
|
|
III. INTRODUCTION |
|
|
These Instructions For Use
contain information on the PRONEB TURBO Compressor
(PRONEB TURBO). Separate Instructions For Use are included with the enclosed PARI
Nebulizer.
..Before using your PRONEB TURBO, you should read and understand the
entire Instructions For Use for both the PRONEB TURBO and PARI Nebulizer. Make special
note of all danger, warning and caution statements. Save this guide for future reference. |
|
|
IV. GETTING
STARTED |
|
|
1. Check the
PRONEB TURBO packing box and make sure all components are included. |
|
|
DESCRIPTION: |
PART NO. |
|
|
PRONEB TURBO Compressor |
|
|
|
Air Filter (in compressor) |
41E4851 |
|
|
PRONEB TURBO Instructions For Use |
DS-38-810 |
|
|
Warranty Card (in nebulizer package) |
DS-00-9999 |
|
|
Power Cord |
41 E8226 |
|
|
PARI Nebulizer Set, Instructions For Use |
|
|
|
If you did
not receive all of the components, please contact the authorized dealer where you
purchased your PRONEB TURBO. |
|
|
2. Fill out the warranty card
completely and mail. |
|
|
V. SET-UP |
|
|
If you have not done so
already, please open page two of these Instructions For Use. The illustrations will come
in handy.
..1. Place the PRONEB TURBO on a stable, flat surface. Place the unit
in an area that is clean and free of dust (Fig.A).
..2. Connect one end of the power cord to the receptacle on the back of
the PRONEB TURBO compressor (Fig.C-1). Connect the power cord plug to wall outlet
(Fig.C-2).
..3. Open the nebulizer package and read and follow the nebulizers
Instructions For Use.
Note: Your PRONEB TURBO compressor has a nebulizer holder on the front of the unit
(Fig.B). This nebulizer holder allows the nebulizer to be placed in the front of the
PRONEB TURBO with the tubing attached. |
|
Next | Back | Proneb
Turbo | Pari | Index |
|
